![]() ![]() In serial transmission, bits are sent sequentially on the same channel (wire) which reduces costs for wire but also slows the speed of transmission. The timing for parallel transmission is provided by a constant clocking signal sent over a separate wire within the parallel cable thus parallel transmission is considered synchronous. However, this speedup is a tradeoff versus cost since multiple wires cost more than a single wire, and as a parallel cable gets longer, the synchronization timing between multiple channels becomes more sensitive to distance. As a result, there is a speedup in parallel transmission bit rate over serial transmission bit rate. ![]() Parallel devices have a wider data bus than serial devices and can therefore transfer data in words of one or more bytes at a time. In parallel transmission, multiple bits (usually 8 bits or a byte/character) are sent simultaneously on different channels (wires, frequency channels) within the same cable, or radio path, and synchronized to a clock. The type of transmission mode used may also depend upon distance and required data rate. Consequently, it is necessary to make a parallel-to-serial conversion at a computer interface when sending data from a computer system into a network and a serial-to-parallel conversion at a computer interface when receiving information from a network. Data between computer systems is usually transmitted in bit serial mode. With the width of the parallel bus matched to the word size of the computer system. Data within a computer system is transmitted via parallel mode on buses Digital data transmission can occur in two basic modes: serial or parallel. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |